Home › General › MAINTENANCE › B58 BATTERY
RM3650E _V1 General _079881 MAINTENANCE _0391789 B58 BATTERY A

MAINTENANCE  B58 BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Disconnect the cable from the negative (-) battery terminal.



·

Unprotected battery terminals.

Risk of short circuits! Risk of fire!

-

Cover the vehicle battery.




PROCEDURE

Hide 64330D 1.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

Hide 64711B 2.REMOVE DECK BOARD ASSEMBLY

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

Check that the START-STOP button (engine switch) off.


HINT:
A439562

Pressing and holding the AUDIO button changes the power source mode to IG OFF.


a.
A442543

Unfasten nut (1).


b.

Disconnect the No. 3 earth wire (2) from the negative (-) battery terminal.

NOTICE:
·

Damage to battery terminal, the safety battery terminal or the battery state sensor.

·

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.





Hide 28800 4.REMOVE BATTERY

CAUTION:
·

Unprotected battery terminals.

Risk of short circuits! Risk of fire!

-

Cover the vehicle battery.




a.
A442547

Release latch mechanism (2) and thread the connector cover (1) out the guides (3) to the top and remove.


b.
A442548

Open the cover (1) of the safety battery terminal.


c.

Unfasten nut (2).


d.

Disconnect the safety battery terminal (3) from the positive (+) battery terminal.

NOTICE:
·

Damage to battery terminal, the safety battery terminal or the battery state sensor.

·

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.





e.
A442549

Pull off the battery hose (1).


f.
A442550

Disengage the No. 1 indoor electrical key antenna assembly (1) from the latch mechanisms (2) of the holder.


g.

Set the No. 1 indoor electrical key antenna assembly (1) aside.


h.
A442551

Unscrew the bolts (1) and remove the bracket (2) of the removable panel.


i.

Unscrew the bolt (3) and remove the battery holder (4).


j.

Remove the battery (5) in the direction of the arrow.