Working on 12 V vehicle electrical system.
Risk of short circuits! Risk of fire!
Disconnect the cable from the negative (-) battery terminal.
Unprotected battery terminals.
Risk of short circuits! Risk of fire!
Cover the vehicle battery.
64330D
1.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
64711B
2.REMOVE DECK BOARD ASSEMBLY
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Check that the START-STOP button (engine switch) off.
Pressing and holding the AUDIO button changes the power source mode to IG OFF.
Unfasten nut (1).
Disconnect the No. 3 earth wire (2) from the negative (-) battery terminal.
Damage to battery terminal, the safety battery terminal or the battery state sensor.
Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.
Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.
28800
4.REMOVE BATTERY
Unprotected battery terminals.
Risk of short circuits! Risk of fire!
Cover the vehicle battery.
Release latch mechanism (2) and thread the connector cover (1) out the guides (3) to the top and remove.
Open the cover (1) of the safety battery terminal.
Unfasten nut (2).
Disconnect the safety battery terminal (3) from the positive (+) battery terminal.
Damage to battery terminal, the safety battery terminal or the battery state sensor.
Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.
Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.
Pull off the battery hose (1).
Disengage the No. 1 indoor electrical key antenna assembly (1) from the latch mechanisms (2) of the holder.
Set the No. 1 indoor electrical key antenna assembly (1) aside.
Unscrew the bolts (1) and remove the bracket (2) of the removable panel.
Unscrew the bolt (3) and remove the battery holder (4).
Remove the battery (5) in the direction of the arrow.