Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
1.REMOVE FRONT WHEEL LH
53876F
2.REMOVE FRONT NO. 2 FENDER LINER
75602C
3.REMOVE HOOD MOULDING
Disengage the claws (2) to remove the hood moulding (1).
76902B
4.REMOVE FENDER PANEL MUDGUARD SUB-ASSEMBLY
When removing the fender panel mudguard sub-assembly, heat the fender panel mudguard sub-assembly using a heat light.
| Item | Temperature |
|---|---|
| Fender Panel Mudguard Sub-assembly | 40 to 50°C (104 to 122°F) |
| *a | Heated Part |
| *b | Heat Light |
Touching heated parts for a long time may result in burns.
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Do not heat the fender panel mudguard sub-assembly excessively.
Using a moulding remover A, remove the fender panel mudguard sub-assembly (1).
5.REMOVE REAR WHEEL LH
65638
6.REMOVE REAR WHEEL HOUSE LINER LH (for LH Side)
Remove the screws (1) and screws (2).
Remove the nuts (3) and rear wheel house liner LH (4).
65637
7.REMOVE REAR WHEEL HOUSE LINER RH (for RH Side)
Remove the screws (1) and screws (2).
Remove the nuts (3) and rear wheel house liner RH (4).
75652
8.REMOVE QUARTER OUTSIDE MOULDING
Remove the nuts (1) and quarter outside moulding (2).
75652A
9.REMOVE NO. 1 QUARTER OUTSIDE MOULDING
When removing the No. 1 quarter outside moulding, heat the No. 1 quarter outside moulding using a heat light.
| Item | Temperature |
|---|---|
| No. 1 Quarter Outside Moulding | 40 to 50°C (104 to 122°F) |
| *a | Heated Part |
| *b | Heat Light |
Touching heated parts for a long time may result in burns.
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Do not heat the No. 1 quarter outside moulding excessively.
Using a moulding remover A, remove the No. 1 quarter outside moulding (1).