Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WHEEL OPENING MOULDING
RM3650E _59 Vehicle Exterior _079982 EXTERIOR PANELS / TRIM _0387970 WHEEL OPENING MOULDING A

EXTERIOR PANELS / TRIM  WHEEL OPENING MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 75652A 1.INSTALL NO. 1 QUARTER OUTSIDE MOULDING

a.
B542626

Remove adhesive residue from the rear bumper cover and clean the adhesive area (1) with cleaner.

Cleaner:

Cleaner R2



b.

Peel off the liner from adhesive tape (2).


c.

Install the No. 1 quarter outside moulding (3) and press firmly.


Hide 75652 2.INSTALL QUARTER OUTSIDE MOULDING

a.
B542624

Install the quarter outside moulding (2) with the nuts (1).

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 65638 3.INSTALL REAR WHEEL HOUSE LINER LH (for LH Side)

a.
B602857

Install the rear wheel house liner LH (4) with the nuts (3).

Torque:
2.6 N*m (27 kgf*cm, 23 in.*lbf)


b.

Install the screws (1) and screws (2).

Torque:
2.6 N*m (27 kgf*cm, 23 in.*lbf)


Hide 65637 4.INSTALL REAR WHEEL HOUSE LINER RH (for RH Side)

a.
B602858

Install the rear wheel house liner RH (4) with the nuts (3).

Torque:
2.6 N*m (27 kgf*cm, 23 in.*lbf)


b.

Install the screws (1) and screws (2).

Torque:
2.6 N*m (27 kgf*cm, 23 in.*lbf)


Hide 5.INSTALL REAR WHEEL LH

Hide 76902B 6.INSTALL FENDER PANEL MUDGUARD SUB-ASSEMBLY

a.
B542622

Remove adhesive residue on the front side panel and clean the adhesive area (1) with cleaner.

Cleaner:

Cleaner R2



b.

Peel off the liner from adhesive tape (2).


c.

Install the fender panel mudguard sub-assembly (3) and press tightly.


Hide 75602C 7.INSTALL HOOD MOULDING

a.
B542620

Engage the claws (2) to install the hood moulding (1).


Hide 53876F 8.INSTALL FRONT NO. 2 FENDER LINER

Hide 9.INSTALL FRONT WHEEL LH