Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM3650E _56 Audio / Visual / Telematics _079983 AUDIO / VIDEO _0387982 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.



·
B475753

Pyrotechnic components.

Danger! Life-threatening injuries!

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

-

Replace any damaged part or ones that have been dropped.




NOTICE:
·

Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.

·

When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.

·

Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.



PROCEDURE

Hide 63310 1.REMOVE ROOF HEADLINING ASSEMBLY

Hide 2.REMOVE NOISE FILTER

a.
E415612

Unlock plug connections (1) and disconnect.


b.

Loosen T25 bolt (2).


c.

Detach the guide (4) to remove the noise filter (3).


Hide 3.REMOVE TRAP CIRCUIT

a.
E415613

Unlock plug connections (1) and disconnect.


b.

Loosen T25 bolt (2).


c.

Detach the guide (4) to remove the trap circuit (3).