Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › MULTI-DISPLAY CONTROLLER
RM3650E _56 Audio / Visual / Telematics _079984 NAVIGATION / MULTI INFO DISPLAY _0387988 MULTI-DISPLAY CONTROLLER A

NAVIGATION / MULTI INFO DISPLAY  MULTI-DISPLAY CONTROLLER  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.




NOTICE:
·

Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.

·

When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.

·

Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.



HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 58804A 1.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 84780A 2.REMOVE REMOTE OPERATION CONTROLLER ASSEMBLY

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Leave electrical components in original packaging until just before they are installed. Use the original packaging only for any return shipments. Always package removed components straight away.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

Antistatic work clothing and antistatic shoes (with ESD symbol).

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
E415854

Loosen T20 screws (1).


b.

Remove the remote operation controller assembly (2).