Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER
RM3650E _56 Audio / Visual / Telematics _079984 NAVIGATION / MULTI INFO DISPLAY _0387990 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.




NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Leave electrical components in original packaging until just before they are installed. Use the original packaging only for any return shipments. Always package removed components straight away.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

Antistatic work clothing and antistatic shoes (with ESD symbol).

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



·

Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.

·

When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.

·

Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.



HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 55011A 1.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 2.REMOVE RADIO RECEIVER ASSEMBLY

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Leave electrical components in original packaging until just before they are installed. Use the original packaging only for any return shipments. Always package removed components straight away.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

Antistatic work clothing and antistatic shoes (with ESD symbol).

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



·

Sensitive optical fibers.

Damaged optical fibers can result in operating failure of the LED.

-

Do not bend optical fibers too much and do not kink, as well. The minimum permissible bending radius is 25 mm.

-

Avoid pressure and tensile loads and heat influences on the optical fiber.



·

Damage to the head unit.

The plug connections of the head unit must not be disconnected if the battery is still connected.

-

Disconnect all batteries.



The hard disk of the head unit can be damaged by vibration.

-

Carry out mechanical work on the head unit and adjacent components with care.




a.
E415630

Loosen T20 screws (1).


b.

Detach the guides (2).


c.

Pull the radio receiver assembly (3).


d.
E415631

Detach the wiring harnesses from the holders (1).


e.

Unlock plug connections (2) and disconnect.


f.
E415632

Detach the clip (2) and guides (3) to remove the cable clip (1).


g.
E415633

Unlock plug connection (1) and disconnect.


h.

Remove the radio receiver assembly (2).


i.
E416848

Remove the plug (1).