Working on 12 V vehicle electrical system.
Risk of short circuits! Risk of fire!
Detach battery earth lead from battery.
Pyrotechnic components.
Danger! Life-threatening injuries!
All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Replace any damaged part or ones that have been dropped.
For additional information see:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.
When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.
Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.
Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
63310
1.REMOVE ROOF HEADLINING ASSEMBLY
86730A
2.REMOVE TELEPHONE MICROPHONE ASSEMBLY
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
Unlock plug connection (1) and disconnect to remove the telephone microphone assembly (2).