Working on 12 V vehicle electrical system.
Risk of short circuits! Risk of fire!
Detach battery earth lead from battery.
Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.
When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.
Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.
64717E
1.REMOVE LUGGAGE COMPARTMENT TRIM FRONT COVER
86725
2.REMOVE MOBILEPHONE BATTERY
Electrostatic discharge.
Damage to or destruction of electrical components.
Leave electrical components in original packaging until just before they are installed. Use the original packaging only for any return shipments. Always package removed components straight away.
Read and comply with user information on using the associated special tool 12 7 060.
Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
Antistatic work clothing and antistatic shoes (with ESD symbol).
For additional information see:
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
|
Remove in this Direction |
Detach the claws (2) and guides (3) to remove the transceiver cover (1) in the direction of the arrow.
Unlock plug connection (1) and disconnect.
Remove the mobilephone battery (2).