1.REMOVE FRONT BUMPER ASSEMBLY
89341M
2.REMOVE FRONT SIDE ULTRASONIC SENSOR
The illustration is for the LH side.
orientation for the RH side is the opposite of the LH side.
Unlock plug connection (1) and disconnect.
Detach the claws (1) to remove the front side ultrasonic sensor (2).
Remove the ultrasonic sensor O-ring (1).
89341K
3.REMOVE FRONT CORNER ULTRASONIC SENSOR
The illustration is for the LH side.
orientation for the RH side is the opposite of the LH side.
Unlock plug connection (1) and disconnect.
Detach the claws (1) to remove the front corner ultrasonic sensor (2).
Remove the ultrasonic sensor O-ring (1).
89341L
4.REMOVE FRONT CENTER ULTRASONIC SENSOR
Use the same procedure as for the front corner ultrasonic sensor.
52536
5.REMOVE FRONT BUMPER SIDE RETAINER LH
52535
6.REMOVE FRONT BUMPER SIDE RETAINER RH
Use the same procedure as for the LH side.
89348
7.REMOVE NO. 1 ULTRASONIC SENSOR RETAINER
Perform this procedure only when replacement of the No. 1 ultrasonic sensor retainer is necessary.
When removing the No. 1 ultrasonic sensor retainer, heat the front bumper assembly and No. 1 ultrasonic sensor retainer using a heat light.
The illustration is for the LH side.
orientation for the RH side is the opposite of the LH side.
Heat the front bumper assembly and No. 1 ultrasonic sensor retainer using a heat light at the specified temperature.
| Item | Temperature |
|---|---|
| Front Bumper Assembly | 40 to 50°C (104 to 122°F) |
| No. 1 Ultrasonic Sensor Retainer |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
for front side:
Remove the No. 1 ultrasonic sensor retainer (1).
for front corner side:
Remove the No. 1 ultrasonic sensor retainer (1).