Home › Engine / Hybrid System › B58 (INTAKE / EXHAUST) › EXHAUST PIPE GAS CONTROL ACTUATOR SUB-ASSEMBLY
RM3650E _51 Engine / Hybrid System _080024 B58 INTAKE / EXHAUST _0388160 EXHAUST PIPE GAS CONTROL ACTUATOR SUB-ASSEMBLY A

B58 INTAKE / EXHAUST  EXHAUST PIPE GAS CONTROL ACTUATOR SUB-ASSEMBLY  REMOVAL  


PROCEDURE

Hide 58723F 1.REMOVE REAR UNDERBODY PROTECTOR RH

HINT:

Use the same procedure as for the LH side.

Click hereEngine / Hybrid System>B58 (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL


Hide 17230E 2.REMOVE ACTUATOR WITH BRACKET ASSEMBLY

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A442352

Unlock plug connection (1) and disconnect.


b.
A442353

Loosen the bolts (1).


c.

Remove the actuator with bracket assembly (2).