Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR
RM3650E _59 Vehicle Exterior _080029 DOOR / HATCH _0388190 BACK DOOR A

DOOR / HATCH  BACK DOOR  REASSEMBLY  


PROCEDURE

Hide 75431A 1.INSTALL NO. 1 BACK DOOR EMBLEM

Hide 68960 2.INSTALL BACK DOOR STAY ASSEMBLY LH

Hide 68950C 3.INSTALL BACK DOOR STAY ASSEMBLY RH

HINT:

Perform the operations on the left and right side.


Hide 4.INSTALL NO. 1 AMPLIFIER ANTENNA ASSEMBLY

Hide 81570 5.INSTALL CENTER STOP LIGHT ASSEMBLY

Hide 67752 6.INSTALL UPPER BACK DOOR TRIM

a.
B506446

Insert the upper back door trim (1) at the guides (2) and secure it with the clamps (3).


Hide 7.INSTALL PIN

HINT:

Perform the operations on the left and right side.


a.
B506449

Position the pin (2).


b.

Tighten the T20 screw (1).


Hide 68961 8.INSTALL BACK DOOR STAY BOLT

HINT:

Perform the operations on the left and right side.


a.
B506450

Using a deep socket wrench 16 mm, position and tighten back door stay bolt (1).


Hide 9.INSTALL SHEET METAL NUT

a.
B458652

Install sheet metal nuts (1).


Hide 69350 11.INSTALL BACK DOOR LOCK ASSEMBLY

Hide 67751 12.INSTALL BACK DOOR TRIM BOARD

a.
B506440

Clip in the back door trim board (2) with the clips (3).


b.

Tighten the T25 screws (1) at the back door trim board (2).

Torque:
2.8 N*m (29 kgf*cm, 25 in.*lbf)


c.
B506439

Clip in the back door trim covers of the screw points (1) in the claws (2).


Hide 64330D 13.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY