Perform the operations on the left and right side.
64330D
1.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
68960
2.REMOVE BACK DOOR STAY ASSEMBLY
Component with preload.
Danger of injury!
Reduce preload as far as possible before disassembly. Relieve component.
Shutting hood sub-assembly or back door panel sub-assembly.
Danger of injury!
Support hood sub-assembly / back door panel sub-assembly in fully open position with the aid of a suitable device.
Push clamps (1) open with a screwdriver in the direction of arrow.
Pull off ball socket of the back door stay assembly (2), top and bottom in the direction of arrow from the back door stay bolt.
Remove back door stay assembly (2).
68961
3.REMOVE BACK DOOR STAY BOLT