64330D
1.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
67751
2.REMOVE BACK DOOR TRIM BOARD
Scratches.
Tools and sharp-edged components can cause scratches.
Protect working area.
Handle tools and components carefully.
Disconnect back door trim covers of the screw points (1) with a suitable tool from the claws (2) and remove.
Loosen T25 screws (1).
Unclip the back door trim board (2) at the clips (3) and remove.
69350
3.REMOVE BACK DOOR LOCK ASSEMBLY
4.REMOVE MULTIPLE-BAND AERIAL
5.REMOVE SHEET METAL NUT
Remove sheet metal nuts (1).
68961
6.REMOVE BACK DOOR STAY BOLT
Perform the operations on the left and right side.
Using a deep socket wrench 16 mm, loosen back door stay bolt (1) and remove.
7.REMOVE PIN
Perform the operations on the left and right side.
Remove T20 screw (1) and pin (2).
67752
8.REMOVE UPPER BACK DOOR TRIM
Using a moulding remover A, disengage the clamps (2) to remove the the upper back door trim on top (1).
81570
9.REMOVE CENTER STOP LIGHT ASSEMBLY
10.REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY
68960
11.REMOVE BACK DOOR STAY ASSEMBLY LH
68950C
12.REMOVE BACK DOOR STAY ASSEMBLY RH
Perform the operations on the left and right side.
75431A
13.REMOVE NO. 1 BACK DOOR EMBLEM