Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › CAMSHAFT OIL CONTROL SOLENOID
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388303 CAMSHAFT OIL CONTROL SOLENOID A

B48 ENGINE CONTROL  CAMSHAFT OIL CONTROL SOLENOID  REMOVAL  


PROCEDURE

Hide 53681 1.REMOVE UPPER FRONT SUSPENSION CENTER BRACE

Hide 55788A 2.REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 12601B 3.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 55789B 4.REMOVE NO. 2 COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 11271A 5.REMOVE REAR CYLINDER BLOCK COVER

Hide 15370J 6.REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY

a.
A441807

Unlock and disconnect both connectors (1).

HINT:

The figure shows the rear side of the engine.



b.
A445900

Position SST correctly on the vanos actuator.

SST
09960-10010  (09962-01000, 09963-00350)

HINT:

The figure shows the rear side of the engine.



c.
A445901

for Intake Side:

i.

Turn the vanos actuator on intake adjuster (1) by approx. 50° in the direction of the arrow with SST and remove it.

SST
09960-10010  (09962-01000, 09963-00350)



d.
A445902

for Exhaust Side:

i.

Turn the vanos actuator on exhaust adjuster (1) by approx. 50° in the direction of the arrow with SST and remove it.

SST
09960-10010  (09962-01000, 09963-00350)