Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › SERVO MOTOR
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388304 SERVO MOTOR A

B48 ENGINE CONTROL  SERVO MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the battery state sensor.

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 12180E 1.REMOVE OIL FILLER CAP ASSEMBLY

Hide 12101A 2.REMOVE OIL PAN DRAIN PLUG

Hide 12101A 3.INSTALL OIL PAN DRAIN PLUG

Hide 15330G 5.REMOVE SERVO MOTOR

a.
A441205

Unlock and disconnect connector (1).


b.
A442147

Loosen T30 bolts (1).


c.
A441207

Using a 4 mm hexagon socket wrench (2), turn the drive shaft of the servo motor (1) in the direction of the arrow.


d.

Make sure that the drive shaft of the servo motor is turned to the end stop of the eccentric shaft at a maximum.


e.

Remove servo motor (1).