Home › Engine / Hybrid System › B48 (INTAKE / EXHAUST) › INTAKE MANIFOLD
RM3650E _51 Engine / Hybrid System _080067 B48 INTAKE / EXHAUST _0388406 INTAKE MANIFOLD A

B48 INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach negative battery terminal from battery.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the battery state sensor.

·

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 51219 2.REMOVE FRONT LOWER SUSPENSION MEMBER PROTECTOR

Hide 3.DRAIN ENGINE COOLANT (for Low Temperature)

Hide 17882 4.REMOVE NO. 2 AIR CLEANER HOSE

Hide 53681 5.REMOVE UPPER CENTER FRONT SUSPENSION BRACE

Hide 55788A 6.REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 11271A 7.REMOVE REAR CYLINDER BLOCK COVER

Hide 23285A 8.REMOVE NO. 1 CHECK VALVE

Hide 17111 11.REMOVE INTAKE MANIFOLD

HINT:

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.


a.
A441261

Unlock the water by-pass hose (1) with a suitable tool (2) and pull it off.


b.
A441761

Detach the hose clamp (1) and tie the water by-pass hose to the side.


c.

Detach the holder (2) and set the engine wire (3) aside.


d.
A441763

Unclip the holder (1) together with the water by-pass hose from the intake manifold (2).


e.
A441762

Unlock plug connection (1) and disconnect.


f.

Unlock and loosen fuel suction tube sub-assembly (2).


g.

Remove holder (3) and set the No. 4 engine wire aside.


h.
A441764

Unlock and disconnect the plug connections (1) and (2).


i.

Place No. 3 engine wire to one side.


j.
A441765

Loosen E10 bolts (1).


k.
A441766

Loosen bolts in the order (5) to (1).

NOTICE:

Additional coolant can escape. Make sure that no coolant enters the intake port of the cylinder head.



l.

Guide the intake manifold out and disconnect the plug connections where required.


m.

Remove intake manifold.


n.
A441835

Remove clip (1).


o.

Loosen T25 bolts (2).


p.

Remove the vacuum sensor assembly (3).


q.

Loosen clip (4).


r.

Loosen T20 bolt (5).


s.

Remove the No. 3 fuel tank breather tube (6).


t.

Loosen screws (7).


u.

Remove throttle body with motor assembly (8).


v.

Replace intake manifold.