Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › AIR FUEL RATIO SENSOR
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388305 AIR FUEL RATIO SENSOR A

B48 ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467A 1.INSTALL WIDE RANGE AIR FUEL RATIO SENSOR

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




a.
A441801

Check the thread (1) and sensor ceramics (2) for damage and replace the wide range air fuel ratio sensor, if necessary.

NOTICE:
·

For wide range air fuel ratio sensor that are reused, the following should be observed.

-

Do not clean the part of the wide range air fuel ratio sensor that does not protrude into the exhaust branch (sensor ceramics).





b.
A446875C01
1.896,0.729 1.979,0.302 true 0.969,1.167 1.208,1.385 0.24,0.219 10 true *a 1.865,0.115 2.323,0.313 0.458,0.198 10 false SST
*a Torque Wrench Fulcrum Length


Using SST, screw the wide range air fuel ratio sensor in and tighten it.

SST
09224-00012  

Torque:
Specified tightening torque : 50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

42.9 N*m (437 kgf*cm, 32 ft.*lbf)




c.
A441805

Position the thermal protection (2) in the direction of the arrow at the wide range air fuel ratio sensor (3).


d.

Replace the cable straps (1).


e.

Secure the thermal protection (2) with the cable strap (1).


Hide 25051 2.INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY