Home › Engine / Hybrid System › B48 (EMISSION CONTROL) › MONOLITHIC CONVERTER
RM3650E _51 Engine / Hybrid System _080100 B48 EMISSION CONTROL _0388643 MONOLITHIC CONVERTER A

B48 EMISSION CONTROL  MONOLITHIC CONVERTER  INSTALLATION  


PROCEDURE

Hide 89467A 2.INSTALL WIDE RANGE AIR FUEL RATIO SENSOR

Hide 25051 3.INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

a.
A441590

Replace the exhaust pipe clamp (1).


b.
A441589

Replace the No.1 turbine outlet elbow gasket (1).


c.
A442373

Feed in and install catalytic converter (3).


d.

Replace the exhaust pipe clamp (2).


e.

Feed in and install exhaust pipe clamp (2).


f.

Tighten down screw (1).

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


g.
A442374

Replace nut (1).


h.

Replace the screw (2).


i.

Replace the screw (3).


j.

Tighten the nut (1) and bolts (2) and (3) on the holder (4) of the exhaust manifold converter sub-assembly.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


k.

Connect the vacuum line.


Hide 89465 5.CONNECT OXYGEN SENSOR

a.
A441800

Position the cable (1) and fasten it at the holders (arrows).


b.
A441799

Clip the connector (2) in at the carrier plate (3).


c.

Connect connector (1).

i.

The connector (1) must engage audibly.



Hide 89467A 6.CONNECT WIDE RANGE AIR FUEL RATIO SENSOR

a.
A441802

Fasten the cable (1) in the holders (arrows).


b.
A441803

Fasten the connector (2) at the carrier plate (3).


c.

Connect connectors (1) and lock.

i.

The connector (1) must engage audibly.



Hide 12601B 7.INSTALL NO.1 ENGINE COVER SUB-ASSEMBLY

Hide 8.CONNECT POSITIVE BATTERY CABLE