Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388308 IGNITION COIL AND SPARK PLUG A

B48 ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 2.REMOVE IGNITION COIL ASSEMBLY

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Damage to the ignition coil assembly.

The silicone hose of the ignition coil assembly must not be contaminated by fuel as this can lead to failure of the ignition coil assembly.

-

Cover ignition coil assembly using suitable covers when working on the fuel system, if necessary remove them.

-

Do not oil or grease the silicone tube of the spark plug connector. The silicone tube is coated with talc to reduce the pulling forces.



·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A442114

Detach the service opening (2) in the marked areas (arrows) and twist it to the side at the pivot point (1).


b.
A442141

Unlock and disconnect the plug connection (1).


c.

Loosen E8 bolt (2).


d.

Remove the ignition coil assembly (3) in the direction of the arrow.


Hide 3.REMOVE SPARK PLUG