Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Electrostatic discharge.
Damage to or destruction of electrical components.
Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
For additional information see:
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
12601B
1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
11102A
2.REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)
Unlock plug connection (1) and disconnect.
Loosen T20 bolt (2).
Remove the camshaft position sensor (3).
11102A
3.REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)
Unlock plug connection (1) and disconnect.
Loosen T20 bolt (2).
Remove the camshaft position sensor (3).