Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › KNOCK SENSOR (for Bank 2)
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388315 KNOCK SENSOR(for Bank 2) A

B48 ENGINE CONTROL  KNOCK SENSOR(for Bank 2)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the battery state sensor.

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 89615 2.REMOVE KNOCK SENSOR

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A442160

Unlock and loosen connector (1).


b.

Loosen E10 bolt (2).


c.

Remove the knock sensor (3).