Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › VACUUM SENSOR
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388316 VACUUM SENSOR A

B48 ENGINE CONTROL  VACUUM SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 89420 2.REMOVE VACUUM SENSOR ASSEMBLY

a.

Turn the START-STOP button (engine switch) off.

HINT:
A439562

Pressing and holding the AUDIO button changes the power source mode to IG OFF.



b.
A442116

Loosen T25 screw (1).


c.

Set the engine wire (2) aside.


d.
A442117

Unlock connector (1) and pull off.


e.
A442118

Loosen T25 screw (1).


f.

Remove the vacuum sensor assembly (2).