Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › ENGINE WIRE HARNESS (for No. 3)
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388318 ENGINE WIRE HARNESS(for No. 3) A

B48 ENGINE CONTROL  ENGINE WIRE HARNESS(for No. 3)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the battery state sensor.

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 82123 3.REMOVE NO. 3 ENGINE WIRE

a.

Overview: No. 3 engine wire (1)

A445907

NOTICE:
·

Damage to wires when disconnecting connectors and plug connections.

Sheared wires can cause a short circuit.

-

Do not pull on the wires when disconnecting connectors and plug connections.





b.
A442111

Release snap-lock couplings (1).


c.

Feed the engine room ECU cover (2) out toward the top and remove.


d.
A441489

Feed the tank ventilation line (1) out and set it aside.


e.

Unlock and loosen lock (2).


f.

Unlock and loosen lock (3).


g.

Unlock and loosen connector (4).


h.

Unlock and loosen holder (5).


i.
A442153

Unlock and loosen all connectors (1) in the direction of the arrow.


j.

Feed the No. 3 engine wire (2) out and remove it.