Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
51219
1.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR
32923L
2.REMOVE NO. 3 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP
Unscrew the T25 screw (1) and remove the No. 3 automatic transmission oil cooler tube clamp (2) for the transmission oil lines.
32923K
3.REMOVE NO. 2 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP
Unclip the cable clip (2).
Loosen E8 bolt (1).
Unclip the transmission oil lines from the No. 2 automatic transmission oil cooler tube clamp (3) for the transmission oil lines.
Remove the No. 2 automatic transmission oil cooler tube clamp (3) for the transmission oil lines.
4.REMOVE CRANKSHAFT POSITION SENSOR
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Electrostatic discharge.
Damage to or destruction of electrical components.
Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
For additional information see:
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Note the installation location of the crankshaft position sensor.
To provide a better overview: Shown with engine removed.
The crankshaft position sensor is located in the marked area (1) on the engine block.
Unlock plug connection (1) and disconnect.
Unscrew the 4 mm hexagon bolt (1) and remove the crankshaft position sensor (2).