17111
1.REMOVE INTAKE MANIFOLD
89429
2.REMOVE OIL TEMPERATURE SENSOR
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Electrostatic discharge.
Damage to or destruction of electrical components.
Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
For additional information see:
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Unlock connector (1) and pull off.
Loosen T30 bolt (1).
Remove the oil temperature sensor (2) from the cylinder block sub-assembly.