12601B
1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
89421R
2.REMOVE AIR PRESSURE SENSOR
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Electrostatic discharge.
Damage to or destruction of electrical components.
Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
For additional information see:
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Unlock plug connection (1) and disconnect.
Unlock plug connection (2) and disconnect.
Unlock the engine ventilation line (3) and set it aside.
Unlock the locks (1).
Feed out wiring harness section for the engine (2) slightly and set it aside.
Loosen T25 screw (1).
Remove the air pressure sensor (2).