Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388349 CAMSHAFT POSITION SENSOR A

B58 ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 11102A 2.REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A441474

Unlock plug connection (1) and disconnect.


b.

Loosen T20 bolt (2).


c.

Thread out and remove the camshaft position sensor of the intake camshaft (3).


Hide 11102A 3.REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A442194

Unlock plug connection (1) and disconnect.


b.

Loosen T20 bolt (2).


c.

Guide the camshaft position sensor of the exhaust camshaft (3) out and remove.