Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388351 CRANKSHAFT POSITION SENSOR A

B58 ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
Hot surfaces.
·

Risk of burning!

-

Perform all work only on components that have cooled down.




PROCEDURE

Hide 51219 1.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 32923L 2.REMOVE NO. 3 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP

a.
A441759

Unscrew the T25 screw (1) and remove the upper section of the No. 3 automatic transmission oil cooler tube clamp (2) for the transmission oil lines.


Hide 32923K 3.REMOVE NO. 2 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP

a.
A441760

Unclip the cable clip (2).


b.

Loosen E8 bolt (1).


c.

Unclip the transmission oil lines from the No. 2 automatic transmission oil cooler tube clamp (3) for the transmission oil lines.


d.

Remove the No. 2 automatic transmission oil cooler tube clamp (3) for the transmission oil lines.


Hide 4.REMOVE CRANKSHAFT POSITION SENSOR

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A442119

Note the installation location of the crankshaft position sensor.

HINT:
·

To provide a better overview: Shown with engine removed.

·

The crankshaft position sensor is located in the marked area (1) on the engine block.




b.
A442120

Unlock plug connection (1) and disconnect.


c.
A442121

Unscrew the 4 mm hexagon bolt (1) and remove the crankshaft position sensor (2).