Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › KNOCK SENSOR
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388358 KNOCK SENSOR A

B58 ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the battery state sensor.

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 89615 2.REMOVE KNOCK SENSOR (for Bank 1)

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A442197

Loosen E8 bolts (1).


b.

Detach coolant line and wiring harness from the intake manifold stay (2).


c.

Guide out and remove intake manifold stay (2).


d.
A442198

Unlock connector (1) and pull off.


e.

Loosen E10 bolt (2).


f.

Remove the knock sensor (3).


Hide 89615 3.REMOVE KNOCK SENSOR (for Bank 2)

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A442199

Unlock connector (1) and pull off.


b.

Loosen E10 bolt (2).


c.

Remove the knock sensor (3).