Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › VACUUM SENSOR
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388360 VACUUM SENSOR A

B58 ENGINE CONTROL  VACUUM SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 89420 2.REMOVE VACUUM SENSOR ASSEMBLY

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.

Turn the START-STOP button (engine switch) off.

HINT:
A439562

Pressing and holding the AUDIO button changes the power source mode to IG OFF.



b.
A442195

Unlock plug connection (1) and disconnect.


c.

Loosen T25 bolt (2).


d.

Remove the vacuum sensor assembly (3).