Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › AIR FUEL RATIO SENSOR
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388361 AIR FUEL RATIO SENSOR A

B58 ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467A 1.INSTALL WIDE RANGE AIR FUEL RATIO SENSOR

a.
A441801

Check the thread (1) and sensor ceramics (2) for damage and replace the wide range air fuel ratio sensor, if necessary.

NOTICE:
·

For wide range air fuel ratio sensors that are reused, the following should be observed.

-

Do not clean the part of the wide range air fuel ratio sensor that does not protrude into the exhaust branch (sensor ceramics).





b.
A446875C02
1.896,0.729 1.979,0.302 true 0.969,1.167 1.208,1.385 0.24,0.219 10 true *a 1.865,0.115 2.323,0.313 0.458,0.198 10 false SST
*a Torque Wrench Fulcrum Length


Using SST, install the wide range air fuel ratio sensor (1).

SST
09224-00012  

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

42.9 N*m (437 kgf*cm, 32 ft.*lbf)




c.

Engage the line of the wide range air fuel ratio sensor in the holder.


d.
A441875

Engage connector (1) on the holder (2).


e.

Connect connectors and lock.


Hide 2.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY