Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › HEATED OXYGEN SENSOR
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388362 HEATED OXYGEN SENSOR A

B58 ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL OXYGEN SENSOR

a.
A441801

Check the thread (1) and sensor ceramics (2) for damage and replace the oxygen sensor, if necessary.

NOTICE:
·

For oxygen sensors that are reused, the following should be observed.

-

Do not clean the part of the oxygen sensor that does not protrude into the exhaust branch (sensor ceramics).





b.
A446873C02
1.99,0.698 2.219,0.281 false 2.104,0.135 2.563,0.333 0.458,0.198 10 true SST 1.156,0.563 1.469,0.76 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Using SST, install the oxygen sensor (1).

SST
09224-00012  

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

42.9 N*m (437 kgf*cm, 32 ft.*lbf)




c.
A441873

Engage the line of the oxygen sensor (2) in the holders (1).


d.
A441876

Engage connector (1) on the holder (2).


e.

Connect connectors and lock.


Hide 2.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY