Home › Vehicle Interior › SEAT › BACK SIDE SUPPORT ADJUSTER ASSEMBLY
RM3650E _58 Vehicle Interior _080097 SEAT _0388591 BACK SIDE SUPPORT ADJUSTER ASSEMBLY A

SEAT  BACK SIDE SUPPORT ADJUSTER ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the driver side and front passenger side.

·

The procedure listed below is for the driver side.



PROCEDURE

Hide 71183C 1.INSTALL SEATBACK SIDE SUPPORT ADJUSTER ASSEMBLY

a.
B539974

Pass the air cushion of seatback side support adjuster assembly (2) through forwards.

HINT:

Use the same procedure for the opposite side.



b.

Attach the spring wire (1) to the separate type front seatback spring assembly.

HINT:

Use the same procedure for the opposite side.



c.
B539971

Replace the T20 screws (1).


d.

Tighten the T20 screws (1) to install the air cushion of seatback side support adjuster assembly (2).

Torque:
1.7 N*m (17 kgf*cm, 15 in.*lbf)

HINT:

Use the same procedure for the opposite side.



e.

w/o Lumbar Support:

i.
B539972

Install the pump (4).


ii.

Install the valve unit (3) to the spring wire.


iii.

Connect the connectors (2).


iv.

Install the tie band (1).



Hide 72760D 2.INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY (w/ Lumbar Support)

Hide 3.INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)

Hide 4.INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)