Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.
1.INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY
Front seat cushion heater assembly is bonded with the separate type front seat cushion pad and cannot be separated from each other without causing damage. Separate type front seat cushion pad and front seat cushion heater assembly must be replaced.
Replace the separate type front seat cushion pad (2).
Position and align the front seat cushion heater assembly (1) on the separate type front seat cushion pad (2) correctly.
Bond the front seat cushion heater assembly (1) to the separate type front seat cushion pad (2).
71071S
2.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER
3.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
71812D
4.INSTALL FRONT SEAT CUSHION SHIELD
72495
5.INSTALL VERTICAL ADJUSTING HANDLE
6.INSTALL NO. 2 RECLINING ADJUSTER RELEASE ARM
71822
7.INSTALL FRONT SEAT SIDE SHIELD
71862
8.INSTALL FRONT SEAT CUSHION INNER SHIELD
9.INSTALL FRONT SEAT ASSEMBLY