Airbag unit.
Danger! Life-threatening injuries!
Before performing any work on the airbag, always disconnect the battery earth lead from the battery.
Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
Replace any damaged part or ones that have been dropped.
For additional information see:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.
When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.
Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.
1.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
2.REMOVE FRONT SEAT ASSEMBLY RH (for Power Seat)
87501
3.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY
for Power Seat:
Seat heater control sub-assembly is installed to the front passenger side.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the guides (1) and guide (2) to remove the seat heater control sub-assembly (3) as shown in the illustration.
Disconnect the connectors (1) from the seat heater control sub-assembly (2).