Home › Engine / Hybrid System › B48 (FUEL) › FUEL TANK
RM3650E _51 Engine / Hybrid System _080098 B48 FUEL _0388606 FUEL TANK A

B48 FUEL  FUEL TANK  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FUEL TANK

a.
A442281

Raise the fuel tank and, while doing so, thread the tank ventilation line (1) through the rear axle support.


b.
A442280

Raise the fuel tank to the installation position, observing the installation position of the tank ventilation line while doing so.


c.

Tighten nut (3).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


d.

Position the retaining straps (2) and tighten the screws (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


e.

Secure the rubber hose (2) on the fuel tank.


f.
A442264

Tighten the hose clamp (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


g.
A442277

Connect and lock the fuel line (1).


h.

Clip the fuel line (1)into the holder (2).


i.

Connect connectors (3) and lock.


j.
A513583

Connect and lock the snap fastener (1).


k.

Clip the tank ventilation line into the holders (2).


l.
A442275

Push on the tank ventilation line (2).


m.

Connect and lock the snap fastener (1).


Hide 37100 2.INSTALL PROPELLER SHAFT ASSEMBLY WITH CENTER BEARING

Hide 65637 3.INSTALL REAR WHEEL HOUSE LINER RH

NOTICE:
A486623

To provide a better overview: Schematic diagram with partially hidden components.


a.

Guide the rear wheel arch cover (3) in.


b.

Tighten the bolts (1) and nuts (2).

Torque:
Screw : 2.6 N*m (27 kgf*cm, 23 in.*lbf)
Nut : 2.6 N*m (27 kgf*cm, 23 in.*lbf)


Hide 4.INSTALL WHEEL ASSEMBLY

Hide 5. FILLING THE FUEL TANK WITH FUEL