Home › Engine / Hybrid System › B58 (FUEL) › FUEL PRESSURE SENSOR
RM3650E _51 Engine / Hybrid System _080099 B58 FUEL _0388624 FUEL PRESSURE SENSOR A

B58 FUEL  FUEL PRESSURE SENSOR  REMOVAL  


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 89458 2.REMOVE FUEL PRESSURE SENSOR

CAUTION:
·

Working on fuel system.

Risk of fire! Danger of explosion!

-

When working on the fuel system, make sure that the workbay is sufficiently ventilated, e.g. using extraction unit.

-

Tightly seal off open lines and connections; collect any escaping fuel directly at the point of exit.

-

No fire, sparks, open flames or smoking.


·

On releasing high pressure line, fuel may emerge at high speed.

Danger of injury!

-

Wear suitable personal protective equipment.

-

Allow the cooling system to cool down to a temperature below 40°C before starting installation work.

-

Note warnings on cylinder head cover.




NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


·

Contaminant or foreign body.

Contamination can result in malfunctions, operating failure or leaks.

-

Adhere to the utmost cleanliness.

-

Protect components from contamination e.g. by covering.

-

Close off line connections with seal plugs.




HINT:

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.


a.
A442226

Unlock plug connection (1) and disconnect.


b.

Release the fuel pressure sensor (2) with the special tool 0 492 027 (32 2 100) and remove.

SST
09600-WA060  


c.

Catch and dispose of escaping fuel.