23470
1.ADJUST FUEL PUMP LIFTER ASSEMBLY
Rotate the cam of the fuel pump assembly drive to the BDC position
Damage to the engine.
The engine may be damaged if it is manually rotated in the wrong direction.
Always rotate the engine in the correct direction of rotation by hand: a) Clockwise, facing the vibration damper or b) Counter-clockwise, facing the chain drive. (b) only applies when the rear timing chain is installed.
Place the depth gauge (1) flat onto the fuel pump assembly flange.
Turn the engine on the central bolt in the direction of engine rotation until the camshaft has reached the BDC position.
The depth gauge (1) is in the deepest position.
Loosen cover (1).
Rotate the engine with the special tool 0 493 380 (11 6 480) in the direction of the arrow until the cam of the fuel pump assembly drive is at the BDC position .
Check the threads (1) on the fuel pump assembly flange for sealing compound residue: Remove sealing compound residue as needed.
Clean the thread (1) with a thread cutter M6.
Make sure that no contamination enters the engine.
Cover opening at the fuel pump assembly flange with suitablematerials.
Replace gasket (1).
23100X
2.INSTALL FUEL PUMP ASSEMBLY
Feed in and install fuel pump assembly (1).
Replace the bolts (arrows).
Compliance with the specification is imperative to make sure that the piston will not break due to twisting.
Position screws (arrows) of the fuel pump assembly (1) and tighten in alternating order in 90° increments.
23802B
3.INSTALL NO. 2 FUEL PIPE SUB-ASSEMBLY
23801P
4.INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY