1. DRAWING OFF FUEL FROM THE FUEL TANK
2.REMOVE WHEEL ASSEMBLY
65637
3.REMOVE REAR WHEEL HOUSE LINER RH
To provide a better overview: Schematic diagram with partially hidden components.
Loosen screws (1).
Unscrew the nuts (2) and feed the rear wheel house liner RH (3) out.
37100
4.REMOVE PROPELLER SHAFT ASSEMBLY WITH CENTER BEARING
5.REMOVE FUEL TANK
Unlock and pull off snap fastener (1).
Pull off the tank ventilation line (2).
Unlock the snap fastener (1) and disconnect the tank ventilation line.
Unclip tank ventilation line from holders (2).
Unlock the snap fastener and pull off the fuel line (1).
Unclip fuel line (1) from the holders (2).
Unlock plug connection (3) and disconnect.
Loosen hose clamp (1).
Pull the fuel tank inlet pipe sub-assembly (2) off the fuel tank.
Heavily support the fuel tank.
Release the screws (1) and remove the fuel tank band sub-assembly (2).
Release the nut (3) and lower as well as remove the fuel tank.
Continue to support the fuel tank.
Have an auxiliary person remove the tank ventilation line (1) towards the wheel arch.
Remove the fuel tank towards the bottom.