Home › Engine / Hybrid System › B48 (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR
RM3650E _51 Engine / Hybrid System _080100 B48 EMISSION CONTROL _0388636 DIFFERENTIAL PRESSURE SENSOR A

B48 EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  REMOVAL  


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 89481B 2.REMOVE DIFFERENTIAL PRESSURE SENSOR

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A441466

Loosen E6 screw (1).


b.

Release the locks (arrows).


c.

Guide out and remove the sensor cover (2).


d.
A441467

Unlock and loosen connector (1).


e.

Pull off the pressure hose (2) from the differential pressure sensor (3) in the direction of arrow and place it to one side.


f.

Guide the differential pressure sensor (3) out of the holder (4) and remove.