16020
1.INSTALL WATER PUMP ASSEMBLY
Check the sealing rings (1) of the coolant lines (2) for damage and replace the coolant lines, if necessary.
Position the water pump assembly (2).
Note the installation position of the component. The component may be installed in various installation positions.
Insert and install the No. 2 water pump bracket sub-assembly (1).
Make sure the No. 2 water pump bracket sub-assembly is fitted correctly.
Tighten nut (3).
Connect and lock the No. 3 radiator hose and No. 2 turbo water pipe sub-assembly (1).
Make sure that the connections are locked correctly. The locks must engage audibly.
Connect connector (2) and lock.
12611
2.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
3.ADD ENGINE COOLANT (for High Temperature)
4.INSPECT FOR COOLANT LEAK (for High Temperature)
51219
5.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR