Home › Engine / Hybrid System › B58 (COOLING) › ELECTRIC WATER PUMP (for Heater)
RM3650E _51 Engine / Hybrid System _080128 B58 COOLING _0388822 ELECTRIC WATER PUMP(for Heater) A

B58 COOLING  ELECTRIC WATER PUMP(for Heater)  INSTALLATION  


PROCEDURE

Hide 16109 1.INSTALL WATER PUMP SUB-ASSEMBLY

a.
A441880

Feed in and install the water pump sub-assembly (2).


b.

Position No. 4 water pump bracket sub-assembly (1).

HINT:

Note the installation position of the component. The component may be installed in various installation positions.



c.
A441879

Tighten nut (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


d.

Connect connectors and lock.

i.

The connector must engage audibly.



e.
A441878

Connect and lock the No. 6 radiator hose (1) to the water pump sub-assembly (2).

HINT:

Make sure that the connections are locked correctly. The locks must engage audibly.



f.
A441877

Connect and lock the No. 7 water by-pass hose (1) to the water pump sub-assembly (2).

HINT:

Make sure that the connections are locked correctly. The locks must engage audibly.



Hide 4.ADD ENGINE COOLANT (for Low Temperature)

Hide 5.INSPECT FOR COOLANT LEAK (for Low Temperature)

Hide 51219 6.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR