Home › Engine / Hybrid System › B58 (COOLING) › FAN SHROUD
RM3650E _51 Engine / Hybrid System _080128 B58 COOLING _0388834 FAN SHROUD A

B58 COOLING  FAN SHROUD  INSTALLATION  


PROCEDURE

Hide 16360A 1.INSTALL FAN WITH MOTOR ASSEMBLY

a.
A442315

Engage the fan with motor assembly at the guides (marks).


b.
A442292

Feed in and install the fan with motor assembly in the direction of the arrow.


c.

Lock the right lock (3).


d.

Tighten down T30 screw (2).

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


e.

Connect connectors (1) and lock.

i.

The connector must engage audibly.



f.
A441867

Secure the automatic transmission oil cooler tube (1) in the holder (2).


g.

Lock holder (2).


Hide 53205 2.INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY

a.
A442467

Position upper radiator support sub-assembly.


b.

Insert bolts (1) and tighten them.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


c.

Insert E14 bolts (2) and tighten.

Torque:
56 N*m (571 kgf*cm, 41 ft.*lbf)


d.

Insert bolts (3) and tighten them.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.
A442531

If applicable, attach the Bowden cables (2).


f.

Clip in housing (1) in the marked areas.


g.
A442524

Position wiring harness (2).


h.

Mount clips (1).


Hide 53295A 3.INSTALL RADIATOR UPPER AIR DEFLECTOR

Hide 52521B 4.INSTALL FRONT BUMPER UPPER RETAINER

Hide 53111M 5.INSTALL FRONT BUMPER INNER SUPPORT

Hide 81150 6.INSTALL HEADLIGHT ASSEMBLY LH

Hide 81110 7.INSTALL HEADLIGHT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.