Home › Engine / Hybrid System › B58 (COOLING) › RADIATOR (for Low Temperature)
RM3650E _51 Engine / Hybrid System _080128 B58 COOLING _0388836 RADIATOR(for Low Temperature) A

B58 COOLING  RADIATOR(for Low Temperature)  REMOVAL  


PROCEDURE

Hide 16360A 1.REMOVE FAN WITH MOTOR ASSEMBLY

Hide 51410 2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 53896B 3.REMOVE FRONT FENDER SPLASH FRONT SHIELD LH

Hide 53895B 4.REMOVE FRONT FENDER SPLASH FRONT SHIELD RH

HINT:

Use the same procedure as for the LH side.


Hide 5. DRAIN ENGINE COOLANT (for Low Temperature)

Hide 16041 6.REMOVE NO. 2 RADIATOR ASSEMBLY

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Life-long fill of coolant!

·

Do not reuse used coolant.

When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.

In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.

·

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.



a.
A442318

Loosen T30 screws (1).


b.

Unlock the lock (2) and remove the radiator lower air guide plate (3) toward the top.


c.
A442334

Unlock and disconnect the No. 5 water by-pass hose (1).


d.

Set No. 5 water by-pass hose (1) aside and secure.


e.
A442347

Feed out No. 2 radiator assembly (1) in direction of arrow and remove.