Home › Engine / Hybrid System › B58 (COOLING) › WATER INLET HOUSING
RM3650E _51 Engine / Hybrid System _080128 B58 COOLING _0388837 WATER INLET HOUSING A

B58 COOLING  WATER INLET HOUSING  REMOVAL  


PROCEDURE

Hide 51219 1.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 2.REMOVE COMPRESSOR WITH PULLEY ASSEMBLY

Hide 3. DRAIN ENGINE COOLANT (for High Temperature)

Hide 16032 4.REMOVE WATER INLET WITH WATER PUMP HOUSING SUB-ASSEMBLY

CAUTION:
·

Hot fluids.

Risk of scalding!

-

Conduct all work in the vehicle wearing appropriate personal protective equipment only.




NOTICE:

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.


a.
A441899

Loosen T30 bolts (2).


b.

Pull No. 2 water by-pass hose (1) out of the engine water pump assembly and set aside.


c.

Unlock the lock (3).


d.

Detach the No. 1 radiator hose (4) and set it aside.


e.
A441901

Loosen the cable clip (1).


f.
A441902

Loosen E10 bolt (1).


g.

Remove automatic transmission oil cooler tube clamp (2) and set aside.


h.
A441903

Loosen E10 bolts (1).


i.
A441904

Loosen E10 bolts (1).


j.

Guide out water inlet with water pump housing sub-assembly to the top.


k.
A441942

Remove water pipe (1).