Home › Vehicle Interior › HEATING / AIR CONDITIONING › B58 COMPRESSOR
RM3650E _58 Vehicle Interior _079885 HEATING / AIR CONDITIONING _0387592 B58 COMPRESSOR A

HEATING / AIR CONDITIONING  B58 COMPRESSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits. Risk of fire.

-

Detach battery earth lead from battery.


·

Refrigerant circuit under high pressure.

Danger of injury.

-

Note and follow safety information on containers.

-

Avoid contact with refrigerant; wear safety goggles and protective gloves.

-

For more information see:





NOTICE:
·

External damage to compressor with pulley assembly.

Excessive force applied during removal will result in damage to the compressor with pulley assembly.

-

Remove the compressor with pulley assembly without damaging it and without applying external force.

-

Avoid impacts/knocks to plastic belt pulley (caused by tools, contact with base).




HINT:
·

If mechanical failure of the compressor with pulley assembly occurs resulting in chips entering the refrigerant circuit, replace the following parts: compressor with pulley assembly, cooler condenser assembly with desiccant insert, line to cooler condenser assembly and compressor oil.

·

When the engine is stopped after the end of the journey, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can last up to 11 minutes. This protects the components. In this case, replacing the electric fan will not remedy the problem.



PROCEDURE

Hide 1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 16360A 2.REMOVE FAN WITH MOTOR ASSEMBLY

Hide 4.REMOVE COMPRESSOR WITH PULLEY ASSEMBLY

CAUTION:
·

Danger of injury.

-

Wear safety goggles and protective gloves when disconnecting the refrigerant line.

-

Seal refrigerant lines with seal plugs.




a.
I114306

Disconnect the connector (1).


b.
I114307

Remove T45 bolt (1) to disconnect the suction pipe sub-assembly (2).


c.

Remove T45 bolt (1) to disconnect the discharge tube G (2).


d.

Remove the O-rings.


e.
I114308

Remove E12 bolts (1).


f.

Feed out and remove the compressor with pulley assembly (2).