Home › Engine / Hybrid System › B58 (COOLING) › WATER INLET HOUSING
RM3650E _51 Engine / Hybrid System _080128 B58 COOLING _0388837 WATER INLET HOUSING A

B58 COOLING  WATER INLET HOUSING  INSTALLATION  


PROCEDURE

Hide 16032 1.INSTALL WATER INLET WITH WATER PUMP HOUSING SUB-ASSEMBLY

a.
A441941

Replace the O-rings (1).


b.

Coat O-rings (1) with coolant for installation.


c.
A441942

Position water pipe (1) up at an angle.


d.
A441819

Replace the gasket (1).


e.

Insert and install the gasket (1) on the water inlet with water pump housing sub-assembly.


f.
A441818

Clean the sealing surface (1).

NOTICE:
·

Damage to the surface.

The use of metal-cutting tools (e.g. emery cloth) to clean the surfaces can damage them and lead to leaks or engine damage.

-

Do not use any metal-cutting tools.





g.
A441904

Insert and install the water inlet with water pump housing sub-assembly.


h.

Tighten the E10 bolt (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


i.
A441903

Tighten the E10 bolts (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


j.
A441902

Position automatic transmission oil cooler tube clamp (2).


k.

Tighten the E10 bolts (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


l.

Mount cable clip.


m.
A441899

Connect No. 1 radiator hose (4).

HINT:

Make sure that the connections are locked correctly. The locks must engage audibly.



n.

Connect No. 2 water by-pass hose (1) on the engine water pump assembly.


o.

Tighten down T30 bolts (2).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 2.INSTALL COMPRESSOR WITH PULLEY ASSEMBLY

Hide 3.ADD ENGINE COOLANT (for High Temperature)

Hide 4.INSPECT FOR COOLANT LEAK (for High Temperature)

Hide 51219 5.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR