1.INSTALL FAN AND GENERATOR V BELT
Component with preload.
Danger of injury!
Reduce preload as far as possible before disassembly. Relieve component.
If the fan and generator V belt for the alternator is reused: Mark the direction of travel and reinstall the fan and generator V belt for the alternator in same direction of travel.
| *a | 4 mm Hexagon Wrench |
Position the fan and generator V belt for alternator (1) on the ancillary components.
Using 16 mm socket wrench, Increase preload on belt tensioner.
Remove 4 mm hexagon wrench from belt tensioner.
17882
2.INSTALL NO. 2 AIR CLEANER HOSE
12601B
3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY