Hot exhaust system.
Risk of burning!
Any work must exclusively be carried out with an exhaust system that has cooled down.
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
12180E
1.REMOVE OIL FILLER CAP ASSEMBLY
12101A
2.REMOVE OIL PAN DRAIN PLUG
12101A
3.INSTALL OIL PAN DRAIN PLUG
25051
4.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
13540
5.REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Have a cloth ready.
A small amount of engine oil emerges during the removal of the No. 1 chain tensioner assembly (1).
Detach and remove the No. 1 chain tensioner assembly (1) from the bottom.